Lacing cord

By on June 4, 2012

If you make a corset you’ll have to find lacing cord for it. Also if you buy your corset and the laces wear out you’ll be wondering what you use as replacement lacing. I recommend not using shoe laces which are often the first port of call for corset making newbies. These stretch and are normally too short. I’ve also seen ribbon used which although it doesn’t stretch will wear out very quickly and start to fray.

It’s best to get lacing cord from a corsetry supplier so don’t forget to order it when you buy your busk and steel bones etc. you can get the flat shoe lace like laces but the tubular stuff is better, it’s a thin round cord and because it isn’t flat it can’t get twisted which looks unattractive.

When you buy get a 3 meter lace if your tightlacing as you’ll have enough slack to not have to re-lace every time you put it on. You can also get continuous lace, so you order say 10 meters and cut and tip it yourself. This is a lot cheaper and the colours available are more varied.

You can tip laces using 3 methods, plastic shrink tubing, metal lace ends and aglets.
For the plastic tubing you need to take needle and thread first and bind the ends of your laces by wrapping the end centimetre tightly. Then cut a centimetre of tube, place it over then lace end and use a lighter to heat it gently. The tube will shrink and grip the lace end.
Metal tips need pliers, you put the end in the tip and squeeze it shut.
Aglets are metal cones with prongs at the open end. You place the lace en in the cone and push the prongs in to hold it in place.

Tags: ,

Technorati Tags: ,

Comments

Be the first to comment.

Leave a Reply

*



You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>